InnoGear Mic Arm vs Triton Audio FetHead
A side-by-side look at InnoGear Mic Arm and Triton Audio FetHead for podcasters: pricing, features, and where each one wins.
InnoGear Mic Arm
Budget scissor arm with 25-inch reach for everyday podcast setups
See site
Check price on Amazon
Triton Audio FetHead
27 dB of Class A FET gain in a 130mm in-line body
See site
Check price on AmazonAt a glance
| InnoGear Mic Arm | Triton Audio FetHead | |
|---|---|---|
| Starting price | See site | See site |
| Free plan | No | No |
| Free trial | No | No |
| Best for | First-time podcasters and streamers who need a functional desk boom arm without spending on a premium brand | Podcasters and broadcasters using low-sensitivity dynamic mics who need a slim, transparent gain stage that sits right at the mic body |
Key features
InnoGear Mic Arm
- 25.6-inch maximum horizontal reach
- 3.3 lb max load capacity
- 360-degree horizontal base rotation
- 270-degree vertical arm adjustment, 250-degree tilt at mic attachment
- Desk clamp: up to 2-inch edge thickness
- 3/8 to 5/8-inch screw adapter included
Triton Audio FetHead
- 27 dB amplification at 3000 ohm load
- Frequency response: 10 Hz - 100 kHz (+/- 1 dB)
- Class A FET circuit, 22 kohm input impedance
- Powered by 24-48V phantom power, balanced XLR in/out
- Compact form factor: 130 x 30 mm
- Compatible with dynamic and ribbon microphones
Pros and cons
InnoGear Mic Arm
Pros
- Accessible price point for first-time buyers
- Compatible with most popular USB and condenser mics
- Folds compact when not in use
Cons
- Spring tension can drift with heavier mics over time
- External cable tie management rather than integrated routing
- Build quality is noticeably below premium arms
Triton Audio FetHead
Pros
- Extended 100 kHz frequency response adds air to dynamic mics
- Slim cylindrical body sits flush on the mic with no bulk
- Transparent Class A gain with a clean noise floor
Cons
- Requires 48V phantom power - dead without it
- Single channel only
- Slightly less gain than Cloudlifter CL-1 (27 dB vs. 25 dB - CL-1 claims up to 25 dB peak)
The verdict
Choose InnoGear Mic Arm if
First-time podcasters and streamers who need a functional desk boom arm without spending on a premium brand.
The InnoGear arm is the most honest budget option in this category: it does the job, it is widely available, and it is inexpensive enough that replacing it is not a painful decision. The 3.3 lb capacity covers USB condenser…
Choose Triton Audio FetHead if
Podcasters and broadcasters using low-sensitivity dynamic mics who need a slim, transparent gain stage that sits right at the mic body.
The FetHead and the Cloudlifter CL-1 compete directly for the same use case, and the choice often comes down to character versus utility. The FetHead's 27 dB gain and 10 Hz - 100 kHz bandwidth give it a slightly extended…